Software setup
43
Example: If you want to filtering a specific network 192.168.0.10 from accessing the HTTP
server at 220.189.78.21 you should add a filter attributes as below:
Protocol type/as Source IP Destination IP
Port Range
Start/End
InBound OutBound
TCP/21 192.168.0.10 220.189.78.21 21/21 Allow Block
*The packets matching the criteria will be blocked; those beyond these filtering rules can pass through the
Broadband Home Router.
If you also want to filtering corresponding service from Internet just need set Inbound to
“Block”.
To Next Page
Loading...