Asko CC4840S - Active Carbon Filter Maintenance; Replacing Light Bulbs; Control Panel Buttons

- 6 -
possible to use the dishwasher for this task).
- After a few washes, the colour of the lters may change. This does not mean they have to be replaced.
If the replacement and washing instructions are not followed, the anti-grease lters may present a re hazard.
• The active carbon lters are used to purify the air which is released back into the room.
The lters are not washable or re-usable and must be replaced at least once every four months.
The active carbon lter saturation level depends on the frequency with which the appliance is used, the type
of cooking performed and the regularity with which the anti- grease lters are cleaned.
• Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with
denatured alcohol or neutral, non-abrasive liquid detergents.
• The light on the cooker hood is designed for use during
cooking and not for general room illumination.
Extended use of the light reduces the average duration of the bulb.
• Replacing halogen light bulbs (Fig. 10).
To replace the halogen light bulbs B, remove the glass pane
C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type.
Caution: do not touch the light bulb with bare hands.
• Commands (Fig. 11):
Warning!
- When activating or deactivating the operations or the alarm, the motor and lights must be switched o.
- This product is supplied with an acoustic indicator (buzzer). Each time any button is pressed, this is conrmed
by an acoustic indicator.
- This function can be deactivated or activated, by simultaneously pressing the ON and TIMER buttons for
ve seconds.
- If your product is a recirculating version, it is necessary to activate the active carbon lters indicator function
which you nd in the paragraph regarding this function.
Button A = light (Softlight)
Starting:
A brief pressure on the light button will turn on the light at the maximum intensity, activating the fast softlight
function.
Adjustment:
By keeping the light button pressed, the intensity can be adjusted from maximum to minimum and vice-
versa.
Switching o:
Quick pressure of the light button.
Button B = OFF and Speed reduction
Adjustment:
A brief pressure of the OFF button will reduce the motor speed. For example the indication on the display goes
from speed 3 to speed 2.
speed 3
speed 2
Switching o:
If the operating speed of the motor is set on level 1 of the display, a brief pressure of the OFF button will switch
o the hood.
speed 1