NOTE!
The dishwasher must not be used without the filter
in place!
Diswashing efficiency can be affected if the course
filter is incorrectly fitted. After cleaning ensure that
filter handle is fully locked with the handle pointing
out of the dishwasher.
Drainage pump
The pump can be accessed from inside the
dishwasher.
1.
Cut the power to the dishwasher by pulling out the
plug from the wall socket!
2.
Remove the coarse filter and pipe section.
3.
Remove the small yellow fitted piece at the left of
the bottom drain (see illustration below).
4.
By inserting your finger into the hole you can turn
the pump blade to release anything blocking it.
5.
Reinstall the fitted piece and filters.
6.
Plug the machine in again.
If the dishwasher still does not start and a whirring
sound is heard, the overflow protection has been
activated.
•
Shut off the water.
•
Remove the plug from the wall socket.
•
Call the service division.
NOTE!
Do not forget to reinstall the fitted piece.
Lower spray arm
Holes and bearings can sometimes become blocked.
1.
Pull the lower spray arm straight up to release it.
2.
Remove any debris using a needle or the like. The
spray arms also have holes underneath.
23
Care and cleaning
To Next Page
Loading...
