26
Customer Care Center
1-800-898-1879
www.askousa.com
Rinse aid
Adding rinse aid
In some cases, drying can be made more e-
cient by using rinse aid.
Machines with indicator on the panel
When the rinse aid has run out and more is
needed, the rinse aid symbol on the panel
lights up*.
1. Turn and lift up the cover of the rinse aid com-
partment to the right of the dispenser. This is
where you top up and set the amount of rinse aid
to be dispensed in each wash.
2. Carefully pour in rinse aid up to the dosage
setting knob.
Alter dosage if required. Do not forget to close
the cover.
*Note!
After lling there may be a short delay before the
signal light goes out.
detegrent dispenser
There is a rell indicator in the middle of the
dispenser (see illustration). If the rell indica-
tor is totally black, there is sucient rinse aid.
However, if the indicator has a more transparent
appearance, you need to top up with rinse aid
(see above).
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hardness,
you may need to change the dosage.
Open the rinse aid cover. Here you will nd the
dispenser’s adjustment dial. Settings 1-6: the
harder the water, the higher the dosage.
When the water hardness exceeds 3 grains, you
should use rinse aid with citric acid (acid rinse
aid).
Too much rinse aid can lead to the build-up of
foam. If your water is particularly soft, you can
dilute the rinse aid (1 part rinse aid, 1 part wa-
ter).
Too much rinse aid can cause streaks on the
dishes, while too little can result in water stains.
Open
Closed
Cover for rinse aid
Open by turning and lifting the cover!
To Next Page
Loading...
Need help?
General
