41
Customer Care Center
1-800-898-1879
www.askousa.com
1. Connect drain hose
The drain hose is routed to an inlet plug on
the sink unit’s water trap.
Cut the drain hose adapter to the appro pri-
ate size for connection to the undersink drain
or garbage disposer. The overall length of the
drain hose must not exceed 14 feet 9 inches.
No part of the drainage hose may be more
than 37-1/2 inches (950 mm) above the bottom
of the dishwasher. The hose must not be run
directly to the oor drain or similar.
The hose must always discharge at least 13-
3/4 inches (350 mm) above the bottom of the
dishwasher.
2. Connect water supply hose
Use the supplied O ring and tighten the con-
nection by hand plus a quarter turn with a
wrench. Open the shuto valve and let the
pressure settle for a while. Check the connec-
tions again to make sure they are not leaking.
3. Connect the plug
Ensure that the power outlet is within the range
of the power cable. Do not use an extension
cord!
The dishwasher must be connected to a
grounded outlet.
Plug
Water connection
Shutoff
valve
Grounded
outlet
Grounded
outlet
To Next Page
Loading...
Need help?
General
