ActionError messages
Unblocking the drain pump. See the chapter Care and
maintenance instructions. If the problem persists, contact your
nearest Customer Care Center.
Overfilling water 1F10
See "Water remains in the dishwasher above the filters" under
"Problem" in the table below. If the problem persists, contact your
nearest Customer Care Center.
Water outlet faultF11
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
Water inlet fault 1F12
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and contact your nearest Customer
Care Center.
Inlet valve leakageF40
Turn off the water supply valve. Remove the plug from the power
outlet and contact your nearest Customer Care Center.
Heater fault 1F41
Contact your nearest Customer Care Center.Diverter faultF45
Clean the coarse and fine filters. If the problem persists, contact
your nearest Customer Care Center.
Water level faultF52
Turn off the water supply valve and contact your nearest Customer
Care Center.
Overfilling water 2F54
To avoid water leakage outside the dishwasher, do not remove
the plug from the power outlet until the water supply valve has
been turned off!
Contact your nearest Customer Care Center.Circulation pump faultF56
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
Water inlet fault 2F67
The water pressure should be 4.2-140 psi.
Contact your nearest Customer Care Center.BLDC drain pump faultF68
Press any button to clear the error message.
34
Troubleshooting
To Next Page
Loading...
Need help?
General
