Asko Dishwasher - Rinse Aid System Management; Refilling the Rinse Aid Reservoir; Adjusting Rinse Aid Dosage Settings

22
Rinse aid
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hardness, it
may be necessary to change the dosage.
Open the rinse aid cover . Here you will nd the
dispenser’s adjustment dial. Settings 1-6: the
harder the water, the higher the dosage.
When the water hardness exceeds 10-12
o
dH
you should use rinse aid with citric acid (acid
rinse aid) if the machine does not have a water
softening lter. If the machine has a water
softening lter, dispense as for soft water.
Too much rinse aid can lead to the build-up
of foam. If your water is particularly soft, you
can dilute the rinse aid (1 part rinse aid, 1 part
water).
Too much rinse aid can cause streaks on the
dishes, while too little can result in water stains.
Open
Closed
Refill indicator
Cover for rinse aid
Open by turning and lifting the cover!
Pour in rinse aid
Rinse aid, helps quicken the drying process.
Machines with indicator on the
panel
When the rinse aid has run out and more is
needed, the rinse aid symbol
on the panel
lights up*.
To ll with rinse aid:
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the amount
of rinse aid to be dispensed in each wash.
2. Carefully pour in rinse aid up to the knob for
dosage setting.
Alter dosage if required. Do not forget to close
the cover.
*NB!
After lling there may be a short delay before the
signal light goes out.
Machines with rell indicator
There is a rell indicator in the middle of the
dispenser (see picture). If the rell indicator
is totally black, there is sucient rinse aid.
However, if the indicator has a more transparent
appearance, you need to top up with rinse aid
(see above).