Asko Dishwasher - Troubleshooting Common Dishwashing Issues; Resolving Unclean Dishes; Addressing Stains and Films on China; Fixing Sticky Film Residue

24
Troubleshooting
Problems Possible causes Action
• The spray arms are not
rotating.
• Old dishwasher detergent.
NB! Detergent is a perishable.
• Incorrect dosage of
detergent.
• Insuciently powerful
dishwashing program.
• Incorrect program chosen.
• Incorrect loading of the
dishwasher.
• Glasses and cups have
tipped over during the wash.
• Dishwasher tted with water
softener is leaking salt.
• Incorrectly set water softener.
• Incorrectly set rinse aid
dispenser.
• The salt compartment is
empty.
• Phosphate-free detergent in
combination with hard water.
• Too high a temperature and/
or too much detergent can
cause etching on (crystal)
glass. Unfortunately this
cannot be remedied, only
prevented!
• Too high dosage of rinse aid.
The dishes are not clean
Stains or a lm on the
china
The china has a whitish-
blue sticky lm
• Lift o the arms and clean.
• Avoid large packs.
• Dispense according to the
level of water hardness.
• Select the Temperature
normal option or switch to a
more powerful program.
• Change to a more intensive
program.
• Do not cover china with large
bowls or similar.
•Avoid placing very tall
glasses in the corners of
baskets.
• Load the china securely.
• Check that the cover of the
salt compartment is properly
screwed on. Otherwise
phone for Service.
• See the chapter on water
softeners.
• See the chapter on rinse aid.
• Top up with salt.
• Change detergent.
• Wash (crystal) glass at a low
temperature and dispense
dishwasher detergent with
care. Contact the dishwasher
detergent manufacturer.
• Reduce dosage. See the
chapter on rinse aid. If the
water is very soft, you could
try diluting the rinse aid (1
part rinse aid, 1 part water).