36
* pulse = number of pulses from the flow sensor to obtain the given quantity of water
** applicable to a machine with spray arm dividers. In stage (with an additional circulation pump)
where no spray arm divider status is indicated, sequential 30 seconds lower arm low pressure, 30 seconds l
ower arm high pressure, 30 seconds upper arm low pressure, 30 seconds upper arm high pressure are
intended.
*** without Spray arm dividers.
SERVICE MENUSERVICE MENU
SERVICE MENUSERVICE MENU
SERVICE MENU
5.2 Programme flow description
Illustrated below is a normal programme (for EU ) and the sequence in which the various components arc
connected.
Normal wash
Component Commentary
Main wash
Drain pump 25 sec
Inlet valve 605 pulse*, 47 sec, 3.1 lit***
535 pulse* 40 sec, 2.7 lit**
Circulation pump 30 sec, Upper arm high pressure**
Pause 1 sec
Circulation pump 60 sec, Upper arm high pressure**
Pause 1 sek
Circulation pump 120 sec, Upper arm high pressure**
Pause 1 sek
Circulation pump, Heater 32°C, Temperature stop
Circulation pump 5 min
Pause 3 sek
Circulation pump 2 min, Upper arm high pressure **
Inlet valve, Circulation 75 pulse*, 6 sec, 0.4 lit
Circulation pump, Combined dispenser 3 sec
Circulation pump 3 min
Circulation pump, Heater 40°C, Temperature stop
Circulation pump 3 min
Circulation pump, Heater 55°C
Circulation pump 39 min
Circulation pump 1 min, Upper arm high pressure**
Drain pump 2 sec SCS stage
Circulation pump 20 sec SCS stage,Upper arm high pressure **
Drain pump 25 sec
To Next Page
Loading...
Need help?
General
