86
MAKING YOUR OWN DRYING PROGRAMS (T760/780)
Anti-crease
This program means that the drum will turn
for three seconds every minute, after the drying
program is completed. You can choose whether
the program will last for 1, 2 or 3 hours. This
program prevents garments from creasing.
If you selected Signal On, an audible signal
will sound each time the drum turns during this
program.
1. Use the
buttons to choose how long
you want the Anti-crease program to run.
2. Confirm and save your choice by pressing the
button once.
TEMPERATURE
You can choose Normal or Low temperature.
1. Press the button once.
2. Use the
buttons to choose the tempe-
rature you want, Normal or Low.
3. Confirm and save your choice by pressing the
button once.
DELAYED STARTING
You can delay the start of your drying program
by up to 12 hours.
If you select Delayed starting, and set it for
example to five hours, the machine will start its
drying program five hours after you have pressed
the start button.
As you step forward to the desired time, the
time delay will be shown in the bottom right
corner of the display, together with the
sym-
bol.
1. Press the
button once.
2. Use the
buttons to choose how long
you want to delay the start of the drying pro-
gram
3. Confirm and save your choice by pressing the
button once.
You have now composed your own drying pro-
gram and saved it.
Next time you want to run this personal drying
program, you only need to press the program
button you chose when you started making these
new settings.
SHORT CUTS
If you don't want to make changes in all the menu
headings to design your personal program, you
can skip the ones that will stay the same.
To go on to the next heading without chang-
ing anything in the heading where you are at the
moment, press the
button once. The settings
of the heading you are leaving will not be chan-
ged.
IMPORTANT
This applies only to the main menu headings. If
you are in one of the options sub-headings, you
have to confirm the present setting by pressing
the
button before going on to the next op-
tion sub-heading.
RESTORING THE PRESET PROGRAM
You can always restore the preset drying program.
Do this:
1. Press and hold down the button for the pro-
gram you want to restore.
2. Keeping the program button pressed in, press
the
button as well.
3. Let go of both buttons. The preset program
is now restored.
To Next Page
Loading...
