13
Functions and Features
of the water heater
Strength against corrosion
The inner drum of your water heater, in-
cluding the water input and output pipes
are enamel plated following the welding
operation are fully protected against cor-
rosion. The heater resistance is protected
against corrosion with Magnesium bar.
Strength against water
pressure
Water heater's inner drum is tested un-
der bar pressure considering the water
mains pressure.
Eective Heat Isolation
The water heater is isolated using a
mm thick polyurethane heat isolation
material between the main body sheet
and the water drum. Thank to this ma-
terial the water in it will be heated rapidly
and cools down slowly.
Limiting Thermostat
The limiting thermostat will disable the
resistance in case of excessive tempera-
tures in the drum or the failure of tem-
perature setting thermostat.
V Automated Switch
You can switch ON and OFF the ther-
mostat using the V-Automated switch.
V-Automated Switch acts as a safety
device. It will disconnect the product
from the mains in case of an electrical
short circuit or the product is switched
OFF. The provided V-Automated
Switch should be installed by an author-
ized service technician only�
Safety Valve
Safety valve is installed on to the cold
water inlet of the water heater. A kind of
safety, this valve will prevent the draining
of the water inside in case of a water cut.
Also the same valve will discharge water
from the drain tip in case of overpressure
in the boiler.
Anti-freeze Safety
When the water temperature inside the
water heater drop below ºC, the heat-
ing resistance is automatically activated
and heats the water up to ºC. AF sym-
bol will be displayed during anti freeze
system work. The anti-freeze safety sys-
tem activates while the water heater is
in stand-by. Install the water heater in a
location without risk of freezing.
Dry Operation Safety
If the device is operated without water
due to any possible reason, the system
will intervene automatically and E error
code is displayed. In this case disconnect
the device using V-automated switch
and ensure that the water heater is filled
with water. After ensuring that it is filled
with water reconnect to the mains supply,
the water heater will commence its nor-
mal operation.
Low Voltage Safety
If voltage is dropped to level harmful for
the device due to voltage fluctuations
then the low voltage safety system is
activated and E is displayed. After the
To Next Page
Loading...
