Aspes ATE51D - Safety Information to Take into Consideration During Cleaning; And Maintenance

8
ommended to perform the
cleaning of the limescale
that may form on the resist-
ance due to the water hard-
ness and the high temper-
atures should be removed
in every two years regularly
by the Authorized Service.
This procedure should be
performed on heating resist-
ance.
• All above-mentioned proce-
dures should be performed
by ASPES Authorized Ser-
vice.
• Hot water, ammoniac and
non-alcohol containing liq-
uid detergents should be
used. Otherwise the surface
may get damaged.
• Clean and maintain the
appliance as stated in the
"Cleaning and Mainte-
nance" section.
• Do not use chemicals. Do
not use substances such as
gasoline, thinner etc.
• Using powder detergent
may result in scratches on
the surface of the water
heater.
– Before installation,
– Before cleaning and
maintenance,
– Before repairs.
• Do not drink the water
drained o from the ap-
pliance. Otherwise, severe
health problems may occur.
• If the appliance will be re-
mounted at a new location,
contact with the authorized
service.
Safety Information to Take
into Consideration During
Cleaning and Maintenance
• To prevent risk of electric
shock, turn o the appliance,
shut down its fuse or switch
gear before cleaning.
• All maintenance and service
works should be performed
by the authorized ASPES
services.
• Magnesium bar used against
the corrosion inside the
drum should be checked
every year and if it worn out,
it should be replaced by the
authorized service.
• To get the optimum per-
formance from your elec-
trical water heater, it is rec-