4
Safety Warnings
Safety Information on
the Installation of the
Appliance
WARNING:Using voltage of
your water heater is Volt.
WARNING: Make sure that
safety valve is installed on to the
cold water inlet. Safety valve has
been set during the manufac-
turing of the product. The set-
ting mechanism should not be
intervened. High pressure water
will flow from safety valve. This
is not a fault and is required ac-
cording to safety standard.
WARNING:The water heater
must absolutely be grounded. If
you use your water heater with-
out plug, absolutely run your
appliance after connecting to
grounded power line by means
of fuse; if you use your water
heater with plug, absolutely run
it by inserting into the grounded
plug. Manufacturing company
shall not be responsible for
any damage due to operating
without grounding.
WARNING:Do not operate
your water heater without mak-
ing sure that it is filled with full
of water. If water is flowing when
you open the hot water tap, it
means that the appliance is full
of water.
WARNING:When the water
heater will be mounted and op-
erated for the first time, ask an
authorized ASPES
service for help.
WARNING:Avoid installing
the water heater in places where
there is a risk of freezing.
WARNING: Do not use elec-
tricity extension cables or multi-
pliers.
WARNING:This appliance
is not intended to be used by
those with physical, sensorial and
mental disability (including chil-
dren) or with lack of experience
and knowledge unless they are
given supervision and method
by a person, who is responsible
for the safety of the appliances,
about using the appliance.
WARNING: If the power ca-
ble is damaged, it should be
replaced by the ASPES au-
thorized service sta in order to
avoid a dangerous situation.
• Installation and repairs
should always be done by
Authorized Service.
• Producing company shall
To Next Page
Loading...
