98
3
Wheelchairs come with a left and right legrest
10.2 LIFTING THE WHEELCHAIR
To fold your chair correctly follow the ‘ASSEMBLY’
instructions in reverse
3
,
2
,
1
.
Then, use the carry handle on the seating surface to
safely lift the wheelchair.
DO NOT lift the wheelchair with an
occupant in the seat. This lifting guide is
for safe handling of the wheelchair only.
WARNING
WARNING! DO NOT lift the wheelchair by
holding it by the legrests or the armrests!
Fold-up the footplates, or remove the
legrests, prior to lifting the chair.
10.3 TRANSPORTING THE WHEELCHAIR
To transport this chair in a motor vehicle it is
suggested that the backrest, seat and footplates are
folded as per the “Lifting the Wheelchair” instructions
above. This will help reduce the overall chair size
in order to fit into the rear boot or backseat of a
standard motor vehicle.
WARNING
WARNING! Aspire Vida Wheelchairs are
NOT crash tested and SHOULD NOT ever
be used as a means of transporting a
user in a motor vehicle.
BOX CONTAINS
Wheelchair frame fitted with rear wheels
• Wheelchair
• Left Legrest
• Right Legrest
• Allen Keys
• User Manual
After assembling the wheelchair, these checks should be completed prior to initial use:
1. Check that the seating surface is locked into place, creating a flat support surface.
2. Check that rear wheels are locked in place.
3. Check that rear brakes engage and disengage.
10. GENERAL OPERATION
10.1 GENERAL OPERATION
It is very important that this wheelchair is used under guidance from all warnings or hazards listed in
this product user manual. Key safety measures should be taken by both users and attendants when
using this wheelchair:
• Avoid quick direction changes.
• Ensure your wheelchair is used on surfaces intended for its use.
• Ensure an attendant is available to assist at all times.
Push
1
Place the wheelchair on levelled ground.
Then pushdown on the side rails of the seat
until flat.
2
Flip up and click backrest into place
IMPORTANT: Ensure your fingers are kept
clear from the pivoting mechanism.
Flip up
*CLICK*
9. PRELIMINARY CHECKS8. ASSEMBLY INSTRUCTIONS
When opening the carton, ensure it is done
in a safe and careful manner.
DO NOT USE a box cutter or sharp
implement as this may damage the product.
For WH&S purposes, lay the carton on
its side with the top of the carton open
and slide the plastic bag out containing
the wheelchair.
1. Insert the legrest into the corresponding
receiver at a 90º angle (as shown).
2. Rotate legrest towards the centre until it
clicks into place. Repeat for the other side.
Rotate
towards centre
L R
To Next Page
Loading...
