2. Drill door.
1. Drill 2-1/8" (54mm) dia. hole (A) thru the door.
Cut notches as shown on template.
See note. (Except Dummy Trim)
2. Drill 1" (26mm) dia. hole (B) in edge of door. Mortise for latch front
1-1/8" (29mm) widex 2-1/4" (57mm) high x 5/32" (4mm) deep.
(Except Dummy Trim) .
3. Drill two (2) 5/16" (8mm) dia. holes (C) thru door. See note.
4. Drill pilot holes (D) for latch screws. 7/64" (2.5mm) dia. (Except Dummy Trim)
NOTE: To avoid splintering wood doors, drill holes (A) and (C) from both
sides of the door.
3. Install latch.
1. Insert latch in door. (Be sure bevel edge of bolt faces strike plate.)
2. Attach with two screws supplied.
4. Unpack lock
Inside Lever Handle
Through Bolts
5400LN Series Grade 1
Cylindrical Lever Lockset
Installation Instructions
2
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
Copyright © 2002, 2013, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
80-9150-0056-010 04/24
B
D
C
A
Inside Rose Support
Assembly
Rose Scalp
Outside Assembly
(stays assembled)
To Next Page
Loading...
