What does six 0.3 s flashes mean on my Assa Abloy Besam SW100 Garage Door Opener?
Six 0.3 s flashes on your Assa Abloy Garage Door Opener indicates that the sync cable is either not connected or defective, which applies to double door setups only. Connect or replace the sync cable.
What does seven 0.3 s flashes mean on my Assa Abloy Besam SW100 Garage Door Opener?
Seven 0.3 s flashes on your Assa Abloy Garage Door Opener indicates that the slave control unit is defective in a double door setup. Check the flash frequency on the Slave LED and take necessary measures in accordance with this table.
How to reset the spring pre-tension on my Assa Abloy Besam SW100 Garage Door Opener?
To reset the spring pre-tension on your Assa Abloy Garage Door Opener: 1. Turn up the potentiometer SPTE until it is possible to loosen the door stop. 2. Remove the door stop and the arm system. 3. Unplug the mains and let the spring close. 4. Unplug the motor plug. 5. Mount the drive arm from the arm system and find the o-pre-tension by moving back and forth. 6. Loosen the arm. 7. Connect the motor plug. 8. Adjust the SPTE to 210º. 9. Connect the mains. 10. Mount the door stop against the closing stop block. 11. Turn down SPTE to 0º - operator is now factory set.
Why Assa Abloy Door Opening System motor doesn't start and the door doesn't open?
If the Assa Abloy Door Opening System's motor doesn't start and the door remains closed, check the following: * Ensure both control switches are set to 'ON'. * Verify the main power switch is active. * Confirm that the presence detection zone is clear of any obstructions. * Deactivate any 'Kill' functions that may be engaged.
General| Brand | Assa Abloy |
|---|---|
| Model | Besam SW100 |
| Category | Garage Door Opener |
| Language | English |
Information on obtaining service and support for Besam automatic door systems.
Ensuring the door system meets industry safety and operational standards.
Essential details provided by Besam for each door installation and operation.
Details on how the SW100 operator functions and its configurations.
Explains the door opening process, speed, and obstruction handling.
Describes the automatic door closing process and latch check.
To Next Page
