How to reset Assa Abloy PIN Door locks?
To reset an Assa Abloy Door lock to factory mode, access the backside of the lock. Remove the installation screw and swing the lock open. Locate the small hole on the right side of the batteries. Insert a paper clip (or similar) into this hole to reset the lock. Then, follow the instructions for programming a new lock.
Why doesn't my Assa Abloy Door lock open with the user code?
If your Assa Abloy Door lock doesn't open with the user code, it could be due to an incorrect user code, or the user may have forgotten the code or is trying to access the wrong cabinet. If it's a public lock and an inspection code is programmed, use that to unlock it if you don't want to delete the user code. This allows you to inspect the cabinet's contents.
What to do if Assa Abloy Door lock doesn't open with user code and the knob is misaligned?
If your Assa Abloy Door lock doesn't open with the user code, the motor might be unable to move the latch to the unlocked position. Ensure the knob points straight to the LED signal. If the bolt is in tension against the frame, turn the knob to the correct position, open the lock with the master code to ensure the latch is open, and bend the bolt slightly to relieve the tension.
Configure the PIN cabinet lock for public access, including master and inspection codes.
Configure the PIN cabinet lock for private use with a master and a user code.
Address situations where the master code is unknown or needs resetting.
Procedure to reset the lock back to factory mode, deleting all codes.
Diagnose and resolve issues when the PIN lock fails to open with a user code.
General| Brand | Assa Abloy |
|---|---|
| Model | PIN |
| Category | Door locks |
| Language | English |
To Next Page