Menu Map for SecureWatch Panels
9 Serial Port Menu
8 Sys. Opts. Menu
7 Outputs Menu
6 Timers Menu
5 Users Menu
4 Point Menu
3 Zone Menu
2 Devices Menu
1 Service Menu
2 Communicators
2 Options
2 WiFi
1 Comms Overview
1 Status
1 GSM
5 Default
4 Test SMS
3 SecureComm
3 IP Monitor
2 Comms Option Menu
1 Modem Card Menu
5 Comms Service Menu
4 Panel Print Menu
6 Dialler Menu
3 Remote User Menu
The GSM-WiFiU communicator can be commissioned through the panel’s
engineering menu structure - see above.
Go into the Engineer mode and scroll down to Serial Port Menu and press YES.
Next, scroll to Dialler Menu, press YES and scroll to Communicators - again,
press YES.
To get the full benefit of the unit, go to both the GSM and WiFi sections of the menu
and press YES in both instances. The first time you enter these sub-menus you will
be asked to enable the GSM and WiFi capabilities of the device.
2 IP Address
2 Disable GSM
2 Disable WiFi
2 Fault Delay
2 Fault Delay
2 Monitor Faults
2 WiFi
1 DHCP Enabled
1 Status
1 Status
1 Monitor Signal
Yes
Yes
10m
10m
Yes
Yes
Yes
1 Monitor Signal
1 IP Settings
1 GSM
5 DNS Server
4 Gateway
4 GMS Network Scan
4 WiFi Network Scan
4 Tamper
3 Subnet Mask
3 Options
3 Options
3 Jam Detect
3 Tamper
If you enable the GSM first, the device
the SecureComm service in the background.
Note: You have to manually Scan for WiFi if you opt to only enable the WiFi system
You will be prompted to key-in the installation ID number - the one you got when you
established the billing details (page 3). You will then be prompted accept a randomly
generated 10-digit alphanumeric. This password can be changed by pressing NO.
Note: Passwords can be 6 to 16 alphanumerical characters in length. Lower & upper cases allowed
We recommend using a strong password and avoiding simple passwords such as “alarm”,
“1111" etc.
will automatically start to establish its links to
!
!
13
To Next Page
Loading...
Need help?
General