20
Menu Map for SecureWave Panels
9 Comms Menu
8 Sys. Opts. Menu
7 Outputs Menu
6 Timers Menu
5 Users Menu
4 Point Menu
3 Zone Menu
2 Devices Menu
1 Service Menu
2 WiFi
1 GSM
2 Communicators
1 Overview
5 Remote User Menu
4 SMS Menu
6 Panel Print Menu
7 Serial Port Equipment
8 SecureComm
3 Monitoring & Voice
The GSM-WiFiU communicator can be commissioned through the panel’s
engineering menu structure - see above.
Go into the Engineer mode and scroll down to Comms Menu and press YES. Next,
scroll to Communicators menu, press YES.
To get the full benefit of the unit, go to both the GSM and WiFi sections of the menu
and press YES in both instances. The first time you enter these sub-menus you will
be asked to enable the GSM and WiFi capabilities of the device.
If you enable the GSM first, the device
the SecureComm service in the background.
Note: You have to manually Scan for WiFi if you opt to only enable the WiFi system
You will be prompted to key-in the installation ID number - the one you got when you
established the billing details (page 3). You will then be prompted accept a randomly
generated 10-digit alphanumeric. This password can be changed by pressing NO.
Note: Passwords can be 6 to 16 alphanumerical characters in length. Lower & upper cases allowed
We recommend using a strong password and avoiding simple passwords such as “alarm”,
“1111" etc.
will automatically start to establish its links to
!
!
2 IP Address
2 Disable GSM
2 Disable WiFi
2 Fault Delay
2 Fault Delay
2 Monitor Faults
2 WiFi
1 DHCP Enabled
1 Status
1 Status
1 Monitor Signal
Yes
Yes
10m
10m
Yes
Yes
Yes
1 Monitor Signal
1 IP Settings
1 GSM
5 DNS Server
4 Gateway
4 GMS Network Scan
4 WiFi Network Scan
4 Tamper
3 Subnet Mask
3 Options
3 Options
3 Jam Detect
3 Tamper
2 Options
1 Status
3 IP Monitor
To Next Page
Loading...
Need help?
General