18
SecureComm Menu - SecureWatch Panels - contd.
All Poll Fault: When enabled, if the GSM-WiFi Universal
communicator loses connection on all available paths to the
SecureComm Server for longer than the poll fail time on the
chosen IP monitoring package, the SecureComm Server will
send a "Heartbeat Loss" IP Signal to the monitoring station.
96336 Server Signals
(Continued)
The AVI Time (audio visual indicator), in seconds, is freely
programmable and is the length of time this feature remains
active when triggered.
If a valid signal is communicated to a ARC, after the system
has been unset the AVI message will display on the keypad
and the keypad buzzer will activate to advise the customer to
contact their monitoring station.
During an AVI event a message is displayed on the keypad.
This AVI Message is freely programmable. The default
message is Call Monitoring i.e. Call the monitoring centre.
96337 AVI
Commissioning GSM-WiFi U - SecureWave Mode
So far we have dealt with commissioning a standalone and a SecureWatch system.
In this section we will look at commissioning using a SecureWave panel.
You will need to go to your
And if you want to control the system via the HKC APP then you will need to set it
up as per page 8.
However, one advantage of connecting the unit to a SecureWave panel is that the
communicator can be commissioned through the panel’s engineering menu
structure and so you are not compelled to use the SmartLink700 app for this task.
Plus you also get the full complement of SecureComm options - more than with a
SecureWatch panel.
Wire the GSM-WiFiU communicator to the SecureWave panel as illustrated in the
next page.
internet browser and type securecomm.hkc.ie as before
to setup the SecureComm billing arrangements - see page 3.