Asus B85M-E/DASH - Page 48

2‑18
Chapter 2: Getting started
CPU Internal Power Configuration
CPU Integrated VR Efficiency Management [Auto]
Allows you to manage the CPU integrated VR efciency. Conguration options: [Auto]
[High Performance] [Balanced]
Power Decay Mode [Auto]
Enable to improve power saving on the Fully Integrated Voltage Regulator as the
processor enters low current mode. Conguration options: [Auto] [Disabled] [Enabled]
Idle Power-in Response [Auto]
Allows you to set the idle power‑in response. Conguration options: [Auto] [Regular]
[Fast]
Idle Power-out Response [Auto]
Allows you to set the idle power‑out response. Conguration options: [Auto] [Regular]
[Fast]
Power Current Slope [Auto]
Allows you to set the power current slope. Conguration options: [Auto] [Level 4] [Level
3] [Level 2] [Level 1] [Level 0] ]Level ‑1] [Level ‑2] [Level ‑3] [Level ‑4].
Power Current Offset [Auto]
Allows you to set the power current offset. Conguration options: [Auto] [100%] [87.5%]
[75%] [62.5%] [50%] [37.5%] [25%] [12.5%] [0%] [‑12.5%] [‑25%] [‑37.5%] [‑50.0%]
[‑62.5%] [‑75%] [‑87.5%] [‑100%]
Power Fast Ramp Response [Auto]
Allows you to set the power fast ramp response. Use the <+> and <‑> keys to adjust
the value.
CPU Internal Power Saving Control
Power Saving Level 1 Threshhold [Auto]
Allows you to set the power saving level 1 threshhold. Use the <+> and <‑> keys to
adjust the value.
Power Saving Level 2 Threshhold [Auto]
Allows you to set the power saving level 2 threshhold. Use the <+> and <‑> keys to
adjust the value.
Power Saving Level 3 Threshhold [Auto]
Allows you to set the power saving level 3 threshhold. Use the <+> and <‑> keys to
adjust the value.
2.4.12 CPU Core Voltage [Auto]
This item allows you to set the CPU core voltage. Increase the voltage when increasing the
core frequency. Conguration options: [Auto] [Manual Mode] [Offset Mode]
The following item appears only when you set the CPU Core Voltage to [Manual Mode].
CPU Core Voltage Override [Auto]
Allows you to set the CPU Core Voltage override. Use the <+> or <‑> keys to adjust the
value. The values range from 0.001V to 1.920V with a 0.001V interval.