Asus B85M-E/DASH - Page 60

2‑30
Chapter 2: Getting started
Flow Control [None]
Flow control can prevent data loss from buffer overow. When sending data, if the
receiving buffers are full, a “stop” signal can be sent to stop the data ow. Once
the buffers are empty, a “start” signal can be sent to re‑start the ow. Hardware
ow control uses two wires to send start/stop signals. Conguration options: [None]
[Hardware RTS/CTS]
VT -UTF8 Combo Key Support [Enabled]
This allows you to enable the VT ‑UTF8 Combination Key Support for ANSI/VT100
terminals. Conguration options: [Disabled] [Enabled]
Recorder Mode [Disabled]
This allows you to enable or disable the Recorded mode to capture Terminal data.
Conguration options: [Disabled] [Enabled]
Resolution 100x31 [Disabled]
This allows you to enable or disable the extended terminal resolution. Conguration
options: [Disabled] [Enabled]
Legacy OS Redirection Resolution [80x24]
This allows you to set the number of rows and columns supported on the Legacy OS.
Conguration options: [80x24] [80x25]
Putty Keypad [VT100]
This allows you to select the FunctionKey and Keypad on Putty. Conguration options:
[VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
Redirection After BIOS POST [Always Enable]
This setting allows you to specify if Bootloader is selected than Legacy console
redirection. Conguration options: [Always Enable] [Bootloader]
Serial Port for Out-of-Band Management/Windows Emergency Management
Services (EMS) Settings
The following items only appears when you set the Console Redirection to [Enabled].
Out-of-Band Mgmt Port [COM0]
Allows remote management of a Windows Server OS through a serial port.
Conguration options: [COM0] [COM1(Pci Bus0, Dev22, Func3)] [COM2(Pci Bus3,
Dev0, Func1)]
Terminal Type [VT-UTF8]
Allows you to set the terminal type for out‑of‑band management.
[VT100] ASCII char set.
[VT100+] Extends VT100 to support color, function keys, et.
[VT‑UTF8] Uses UTF8 encoding to map Unicode chars onto 1 or more bytes
[ANSI] Extended ASCII char set
Bits per second [115200]
Selects serial port transmission speed. The speed must be matched on the other side.
Long or noisy lines may require lower speeds. Conguration options: [9600] [19200]
[57600] [115200]