ASUS CUSL2-C User’s Manual 47
4. BIOS SETUP
4. BIOS SETUP
6. When prompted to confirm the BIOS update, press Y to start the up-
date.
Updating BIOS
NOTE: When you see the message “Boot Block is different”, you
may still press <Y> to update the BIOS. Yet if the update fails, your
system will run a greater risk of boot failure depending on whether
the boot block is damaged or not.
7. The utility starts to program the new BIOS information into the flash
ROM. The boot block will be updated automatically only when neces-
sary. This will minimize the chance that a failed update will prevent
your system from booting up. When the programming is finished,
Flashed Successfully will be displayed.
To Next Page
Loading...
Need help?
General
