Asus H97M-E - Irq Assignments for this Motherboard; Clear RTC RAM; Jumpers

IRQ assignments for this motherboard
A B C D E F G H
PCIEx16_1 shared – – – – – – –
PCIEx1_1 – – – shared – – – –
PCIEx1_2 shared – – – – – – –
PCIEx1_3 – shared – – – – – –
LAN – – shared – – – – –
USB2.0controller1 – – – – – – – shared
USB2.0controller2 – – – – shared – – –
USB3.0controller – – – – – shared – –
HDaudio – – – – – – shared –
SATAcontroller1 – – – shared – – – –
SATAcontroller2 – – – shared – – – –
1.6 Jumpers
Clear RTC RAM (3-pin CLRTC)
ThisjumperallowsyoutocleartheRealTimeClock(RTC)RAMinCMOS.Youcan
cleartheCMOSmemoryofdate,time,andsystemsetupparametersbyerasingthe
CMOSRTCRAMdata.TheonboardbuttoncellbatterypowerstheRAMdatain
CMOS,whichincludesystemsetupinformationsuchassystempasswords.
To erase the RTC RAM:
1. TurnOFFthecomputerandunplugthepowercord.
2. Movethejumpercapfrompins1-2(default)topins2-3.Keepthecaponpins2-3
forabout5-10seconds,thenmovethecapbacktopins1-2.
3. PlugthepowercordandturnONthecomputer.
4. Holddownthe<Del>keyduringthebootprocessandenterBIOSsetuptore-
enter data.
ExceptwhenclearingtheRTCRAM,neverremovethecaponCLRTCjumperdefault
position.Removingthecapwillcausesystembootfailure!
H97M-E
H97M-E Clear RTC RAM
1 2 2 3
Normal
(Default)
Clear RTC
CLRTC
1-10
Chapter 1: Product introduction