Asus M4A88TD-M/USB3 - Installing Serial ATA Hard Disks; Setting the RAID Item in BIOS

ASUS M4A88TD-M/USB3 4-15
Chapter 4
4.5.3 Setting the RAID item in BIOS
You must enable the RAID function in the BIOS Setup before creating RAID volume(s) using
SATA HDDs. To do this:
1. Enter the BIOS Setup during POST.
2. Go to the
Main menu > SATA Conguration, and then press <Enter>.
3. Set the type of the SATA connectors to
[RAID].
4. Save your changes, and then exit the BIOS Setup.
See section 3.4.2 SATA Conguration for details.
4.5.2 Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance, install
identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID conguration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.