Asus M4A88TD-M/USB3 - Power, Boot, Tools, and Exit Options

3-28 Chapter 3: BIOS setup
Chapter 3
3.7 Power menu
The Power menu items allow you to change the settings for the Advanced Power
Management (APM). Select an item then press <Enter> to display the conguration options.
3.7.1 Suspend Mode [Auto]
Allows you to select the Advanced Conguration and Power Interface (ACPI) state to be used
for system suspend.
[Auto] The system automatically congures the ACPI suspend mode.
[S1 (POS) only] Sets the ACPI suspend mode to S1/POS (Power On Suspend).
[S3 only] Sets the ACPI suspend mode to S3/STR (Suspend To RAM).
3.7.2 ACPI 2.0 Support [Enabled]
[Disabled] The system will not add additional tables as per ACPI 2.0 specications.
[Enabled] The system adds additional tables as per ACPI 2.0 specications.
3.7.3 ACPI APIC Support [Enabled]
[Disabled] The system disables the Advanced Conguration and Power Interface
(ACPI) support in the Advanced Programmable Interrupt Controller (APIC).
[Enabled] The ACPI APIC table pointer is included in the RSDT pointer list.
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
M4A88TD-M/USB3 BIOS Setup
Main Ai Tweaker Advanced Power Boot Tools Exit
Select the ACPI state
used for System
Suspend.
←→ Select Screen
↑↓ Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
Power Settings
Suspend Mode [Auto]
ACPI 2.0 Support [Enabled]
ACPI APIC Support [Enabled]
APM Conguration
HW Monitor Conguration
Anti Surge Support [Enabled]
NB Thermal Protect [Enabled]
Version 0205
USB Mass Storage Reset Delay [20 Sec]
Sets the maximum time that the BIOS waits for the USB storage device to initialize.
Conguration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to set the emulation type. Conguration options: [Auto] [Floppy]
[Forced FDD] [Hard Disk] [CDROM]