Asus Pro WS X299 SAGE II - Installing Three Crossfirex Graphics Cards

ASUS Pro WS X299 SAGE II
5-3
Chapter 5
5. Connect two independent
auxiliary power sources from
the power supply to the two
graphics cards separately.
6. Connect a VGA or a DVI
cable to the graphics card.
5.1.4 Installing three CrossFireX™ graphics cards
To install three CrossFireX™ graphics cards:
1. Prepare three CrossFireX™-ready graphics cards.
2. Insert the three graphics card into the PCIEX16 slots. If your motherboard has more
than three PCIEX16 slots, refer to Chapter 1 in this user manual for the locations of
the PCIEX16 slots recommended for multi-graphics card installation.
3. Ensure that the cards are properly
seated on the slots.
4. Align and rmly insert the two
CrossFireX™ bridge connectors to
the goldngers on each graphics
card. Ensure that the connectors are
rmly in place.
5. Connect three independent
auxiliary power sources from the
power supply to the three graphics
cards separately.
6. Connect a VGA or a DVI cable to
the graphics card.