Asus Pro WS X299 SAGE II - Installing Four SLI-Ready Graphics Cards

ASUS Pro WS X299 SAGE II
5-9
Chapter 5
4. Align and rmly insert the 3-way SLI
®
bridge connector to the goldngers on
each graphics card. Ensure that the
connector is rmly in place.
5. Connect three independent auxiliary
power sources from the power supply
to the three graphics cards separately.
6. Connect a VGA or a DVI cable to the
graphics card.
3-way SLI
®
bridge
5.2.4 Installing four SLI-ready graphics cards
To install four SLI-ready graphics cards:
1. Prepare four SLI-ready graphics cards.
2. Insert the four graphics cards into the PCIEX16 slots. If your motherboard has more
than two PCIEX16 slots, refer to Chapter 1 in this user manual for the locations of the
PCIEX16 slots recommended for multi-graphics card installation.
3. Ensure that the cards are properly seated on the slots.
4. Align and rmly insert the 4-way SLI
®
bridge connector to the goldngers on each
graphics card. Ensure that the connector is rmly in place.
5. Connect four independent auxiliary power sources from the power supply to the four
graphics cards separately.
6. Connect a VGA or a DVI cable to the graphics card.
4-way SLI
®
bridge