3-20
Chapter 3: BIOS Setup
Chapter 3
3.7 Monitor menu
The Monitor menu displays the system temperature/power status, and allows you to change
the fan settings.
Q-Fan Configuration
Q-Fan Tuning
Click this item to automatically detect the lowest speed and configure the minimum
duty cycle for each fan.
CPU Q-Fan Control
[Disabled] Disable the Q-Fan control feature.
[Auto] Detects the type of CPU fan installed and automatically switches
the control modes.
[DC mode] Enable the CPU Q-Fan control in DC mode for 3-pin CPU fan.
[PWM mode] Enable the CPU Q-Fan control in PWM mode for 4-pin CPU fan.
Chassis Fan(s) Configuration
Chassis Fan 1/Fan 2 Q-Fan Control
[Disabled] Disable the chassic Q-Fan control feature.
[Auto] Detects the type of chassis fan installed and automatically
switches the control modes.
[DC mode] Enable the chassis Q-Fan control in DC mode for 3-pin
chassis fan.
[PWM mode] Enable the chassis Q-Fan control in PWM mode for 4-pin
chassis fan.
Water Pump+/AIO PUMP Control
[Disabled] Disable the Water Pump control feature.
[Auto] Detects the type of water pump installed and automatically switches
the control modes.
[DC mode] Enable the Water Pump control in DC mode for 3-pin chassis fan.
[PWM mode] Enable the Water Pump control in PWM mode for 4-pin chassis
fan.
3.8 Boot menu
The Boot menu items allow you to change the system boot options.
Fast Boot
[Disabled] Allows your system to go back to its normal boot speed.
[Enabled] Allows your system to accelerate the boot speed.
The following items appear only when you set the Fast Boot to [Enabled].
Next Boot after AC Power Loss
[Normal Boot] Returns to normal boot on the next boot after an AC power loss.
[Fast Boot] Accelerates the boot speed on the next boot after an AC power
loss.
To Next Page
Loading...
