Asus ROG STRIX B450-E Gaming - Onboard Devices Configuration and APM

ROG STRIX B450-E GAMING
3-17
Chapter 3
3.6.7 APM Configuration
The items in this menu allow you to set system wake and sleep settings.
ErP Ready
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Conguration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
3.6.8 Network Stack Configuration
The items in this menu allow you to congure Ipv4 / Ipv6 PXE support.
PCIEX16_2 Mode
This item allows you to set the link speed for second VGA slot.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
M.2_1 Link Mode
This item allows you to set the link speed for M.2_1 device.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
M.2_2 Link Mode
This item allows you to set the link speed for M.2_1 device.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
SB Link Mode
This item allows you to set the link speed for Southbridge.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
RGB LED lighting
When system is in working state
This item allows you to turn the RGB LED lighting on or off when the system is in the
working state.
Conguration options: [On] [Off]
When system is in sleep, hibernate or soft off states
This item allows you to turn the RGB LED lighting on or off when the system is in the
sleep, hibernate or soft off states.
Conguration options: [On] [Off]
Intel LAN Controller
This item allows you to enable or disable the Intel LAN controllers.
Conguration options: [Disabled] [Enabled]