Asus RS700-E7/RS4 - Page 91

ASUS RS700-E7/RS4 5-27
ID0 Completion Enable [Disabled]
If supported by hardware and set to ‘Enabled’, this permits setting the number of
ID-Based Ordering (ID0) bit (Attribute [2]) requests to be initiated.
Conguration options: [Disabled] [Enabled]
LTR Mechanism Enable [Disabled]
If supported by hardware and set to ‘Enabled’, this enables the Latency Tolerance
Reporting (LTR) Mechanism. Conguration options: [Disabled] [Enabled]
End-EndTLPPrexBlocking[Disabled]
If supported by hardware and set to ‘Enabled’, this function will bolck forwarding of
TLPs containing End-End TLP Prexes.
Conguration options: [Disabled] [Enabled]
PCI Express GEN2 Link Register
Target Link Speed [Auto]
Conguration options: [Auto] [Force to 2.5 GT/s] [Force to 5.0 GT/s]
Clock Power Management [Disabled]
Conguration options: [Disabled] [Enabled]
Compliance SOS [Disabled]
Conguration options: [Disabled] [Enabled]
Hardware Autonomous Width [Enabled]
Conguration options: [Enabled] [Disabled]
Hardware Autonomous Speed [Enabled]
Conguration options: [Enabled] [Disabled]