Asus SP97 - What the Parameters Stand for

68 ASUS SP97-V User’s Manual
1.3 What the Parameters Stand for?
The meaning of parameters used by SVGAUTL.EXE are explained below:
Syntax:
>SVGAUTL [/D:mode_no] [/F0:n0] [/F1:n1] [/F2:n2] [/F3:n3] [/PA:ta] [/PB:tb]
where
/D: Set the Video Mode to be mode_no which is a hex number.
For example: Set 1024x768 256 color graphic mode.
>SVGAUTL /D:38 <Enter>
/F0: For 640x480, set frame rate to be n0 Hz.
Three availabe frame rates are 60, 72, and 75 Hz.
For example : Set 640x480 graphic mode with 60Hz frame rate
>SVGAUTL /F0:60 <Enter>
/F1: For 800x600, set frame rate to be n1 Hz.
Four availabe frame rates are 56, 60, 72, and 75 Hz.
For example : Set 800x600 graphic mode with 72Hz frame rate.
>SVGAUTL /F1:72 <Enter>
/F2: For 1024x768, set frame rate to be n2 Hz.
Four availabe frame rates are 87 (Interlace), 60, 70, and 75 Hz.
For example : Set 1024x768 graphic mode with 60Hz frame rate.
>SVGAUTL /F2:60 <Enter>
/F3: For 1280x1024, set frame rate to be n3 Hz.
Two availabe frame rates are 87 (Interlace) and 60 Hz.
For example : Set 1280x1024 graphic mode with 60Hz frame rate.
>SVGAUTL /F3:60 <Enter>
/PA: Set Standby Timer to be ta minutes. (0 < ta < 15 min.)
For example : Set Standby Timer be 5 minutes.
>SVGAUTL /PA:5 <Enter>
/PB: Set Suspend Timer to be tb minutes. (0 < tb < 15 min.)
For example : Set Suspend Timer be 5 minutes.
>SVGAUTL /PB:5 <Enter>
Note: 1. Suspend Time would be “ta + tb”. (i.e. standby time + suspend time)
2. The timers will not be very accurate and would just be around the time.
VIII. DOS UTILITY
(SVGAUTL.EXE)
VIII. DOS UTILITY