Asus SP97 - Autoshade R2.0 Setup

ASUS SP97-V User’s Manual 89
IX. SOFTWARE DRIVERS
(AutoCAD R2.0)
IX. Software Drivers
5.3 AutoShade R2.0 Setup
1. The following procedures assume that
(1) You have complete “unpack & copy” procedure.
(2) Your ADI 4.2 drivers are located in C:\ADI42.
2. Add the following settings to your batch file for AutoShade R2.0 (say
SHADE2.BAT) or to your “AUTOEXEC.BAT” file.
(a) For display driver setting, SET DSPADI=\ADI42\RCPSIS.EXP.
(b) For rendering driver setting, SET RDPADI=\ADI42\RCPSIS.EXP.
3. Delete the configure file SHADE.CFG.
4. Type SHADE2 <Enter> to re-configure the AutoShade.
5. While prompting “Select display device:”, choose “P386 AutoDesk Device In-
terface display driver.”
6. While prompting “Select rendering display driver:”, choose “P386 AutoDesk
Device Interface rendering driver.”
7. Go through all the instructions, the system would start with the desired display
setting.