4-8 Chapter 4: BIOS setup
Updating the BIOS file
1. At the FreeDOS prompt, type bupdater /pc /g and press <Enter>.
ASUSTek BIOS Updater for DOS V1.07
Current ROM
Update ROM
A:
Note
[Enter] Select or Load [Tab] Switch [V] Drive Info
[Up/Down/Home/End] Move [B] Backup [Esc] Exit
V6-P8H61ELX.ROM 4194304 2011-07-22 17:30:48
PATH: A:\
BOARD: V6-P8H61ELX
VER: 0105
DATE: 07/22/2011
BOARD: Unknown
VER: Unknown
DATE: Unknown
D:\>bupdater /pc /g
2. The BIOS Updater screen appears as below.
3. Press <Tab> to switch between screen elds and use the <Up/Down/Home/End>
keys to select the BIOS le and press <Enter>. BIOS Updater checks the selected
BIOS le and prompts you to conrm BIOS update.
Are you sure to update BIOS?
Yes No
DO NOT shut down or reset the system while updating the BIOS to prevent system boot
failure!
4. Select Yes and press <Enter>. When BIOS update is done, press <ESC> to exit
BIOS Updater. Restart your computer.
• For BIOS Updater version 1.04 or later, the utility automatically exits to the DOS
prompt after updating BIOS.
• Ensure to load the BIOS default settings to ensure system compatibility and stability.
Select the Load Optimized Defaults item under the Exit menu. Refer to section 4.8
Exit menu for details.
• Ensure to connect all SATA hard disk drives after updating the BIOS le if you have
disconnected them.
To Next Page
Loading...
Need help?
General
