EN 31
Symptom Possible cause Solution
A fuse blows as soon as the
hob is switched on.
The hob has been wrongly
connected.
Check the electrical
connections.
Error code
or Er03
The control panel is dirty or
has water lying on it.
Clean the control panel.
You have touched two or more
keys at the same time.
Do not operate more than one
key at the same time.
Error code E2
Appliance is too hot. Let the appliance cool down.
Error code Er47 or Er400
The hob is wrong connencted
to the mains power supply.
Let the power connection
checked by an installer.
Error code E5 or E6
Power supply failure/Power
voltage wrong.
Let the power connection
checked by an installer.
Error code E8
The air inlet is obstructed. Check air inlet.
Other error code
Other defect. Contact the service
department.
TROUBLESHOOTING
To Next Page
Loading...
