GB 25
Safety instructions for the installation
• e connection must comply with national and local regulations.
• e appliance must always be earthed.
• is appliance may only be connected by a competent
electrical installer.
• For the connection, use an approved cable (for example type
HO7RR) in accordance with the regulations. e cable casing
should be of rubber.
• e connection cable must hang freely and is not to be fed
through a drawer.
• If you want to make a fi xed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is fi tted in
the supply line.
• e worktop the hob is built into must be fl at.
• e walls and the worktop surrounding the appliance must be
heat resistant up to at least 85 °C. Even though the appliance
itself does not get hot, the heat of the hot pan could discolour or
deform the wall.
• Damage caused by incorrect connection, installation or use, will
not be covered by the guarantee.
Clearance
Suffi cient all-round clearance is essential to the safe use of the hob.
Check that there is enough clearance.
cooker hood
cabinet
side wall
hob
GeneralINSTALLATION INSTRUCTIONS
*
HI6271T: min. 60 cm
To Next Page
Loading...
