If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first. Phone
the service department if the advice given below does not help.
Only authorised personnel may open the appliance or carry out work
on the mains power supply.
Damage caused by incorrect connection, incorrect installation or
incorrect use is not covered by the warranty.
In the case of faults visit the internet site
www.atag.nl.
Fault
Cooking zones do not get hot.
Cause
– Appliance incorrectly
connected.
– Plug not, or not completely,
in the socket.
– Fuse(s) in the meter
cupboard defective.
Solution
– See the installation
instructions for correct
connection..
– Put the plug into the socket
– Check the fuses in the meter
cupboard.
FAULTS
table
72
To Next Page
Loading...
Need help?
General
