Atag HL6271T - User Manual

Questions and Answers

M
megan86Aug 10, 2025
Why does the fuse blow when I switch on my Atag HL6271T?
- T
  Terri RangelAug 10, 2025
  If a fuse blows as soon as you switch on your Atag hob, it indicates that the hob has been wrongly connected. Double-check the electrical connections to ensure they are correct.
R
roweericAug 16, 2025
What does fault code E2 mean on my Atag HL6271T?
- V
  Vanessa MaldonadoAug 16, 2025
  If your Atag hob displays fault code E2, the electronics may have overheated, possibly because a too-large pan was placed on the front right cooking zone or the hob is insufficiently ventilated. Let the hob cool down until the code disappears and ensure it is sufficiently ventilated.
G
gcastilloAug 22, 2025
What to do if my Atag Hob shows a fault code after touching two buttons?
- D
  denisediazAug 22, 2025
  If your Atag hob displays a fault code because you touched 2 buttons at the same time, operate only 1 button at a time.
N
nfranklinAug 28, 2025
Why does my Atag HL6271T make a ticking sound?
- C
  Caleb LoweAug 28, 2025
  The ticking sound you hear in your Atag hob is caused by the capacity limiter on the front and back zones, and can also occur at lower settings. This is normal operation.
C
Charles HarrisSep 3, 2025
Why does my new Atag HL6271T have a smell when I use it?
- E
  Emma HarrellSep 3, 2025
  A slight smell is noticeable the first few times the Atag hob is used because the new appliance is heating up. This is normal and will disappear once it has been used a few times. Ventilate the kitchen.