EasyManua.ls Logo

Atag i36C

Atag i36C
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ATAG i Series Boiler Fault Finding 02/10/23.
(All models and generations).

Other manuals for Atag i36C

Question and Answer IconNeed help?

Do you have a question about the Atag i36C and is the answer not in the manual?

Atag i36C Specifications

General IconGeneral
BrandAtag
Modeli36C
CategoryBoiler
LanguageEnglish

Summary

ATAG i Series Boiler Fault Finding Guide

1 st Generation Boiler Fault Finding

Troubleshooting guide for ATAG i Series 1st generation boilers, covering various fault codes and solutions.

10 Description: Outside sensor error

Troubleshoots issues related to the outside sensor, checking connections and resistance.

20 Description: Flow sensor error

Diagnoses flow sensor errors by checking T1 value range, wiring, and resistance.

61 Description: Bus communication error

Addresses errors in bus communication between the boiler and controller, checking connections and power.

118 Description: Water pressure too low

Guides on resolving low water pressure issues, checking system pressure and leaks.

133 Description: No flame detected

Troubleshooting ignition errors and no flame detection, checking gas valve and electrodes.

2 nd Generation Boiler Fault Finding

Fault finding procedures for ATAG i Series 2nd generation boilers, including specific fault codes.

1 P1 Description: Flow check 1 error

Diagnoses flow check 1 errors related to rapid temperature changes in supply water.

114 Description: Outside sensor absent

Troubleshoots absent outside sensor errors, checking connections, wiring, and settings.

118 Description: Flow and return probe plausibility checks failed

Addresses failed plausibility checks for flow and return sensors, often due to reversed readings.

141 Description: no flow detected

Troubleshoots no flow detection faults, checking flow switch, pump wiring, and system flow.

303 Description: PCB Error

Diagnoses PCB errors caused by software or hardware issues, checking voltages and connections.

3 rd Generation Boiler Fault Finding

Fault finding guide for ATAG i Series 3rd generation boilers with detailed explanations of fault codes.

1 P1 Description: Flow check 1 error

Diagnoses flow check 1 errors related to rapid temperature changes in supply water.

114 Description: Outside sensor absent

Troubleshoots absent outside sensor errors, checking connections, wiring, and settings.

140 Description: Working pressure test error 2 times (pump kick)

Addresses working pressure test errors and pump kick issues, checking pressure and pump operation.

201 Description: T3 Hot water sensor defective.

Diagnoses defective T3 hot water sensor issues, checking resistance and wiring.

612 Description: Fan Failure

Troubleshoots fan speed issues, checking fan speed and resistances against specifications.

Boiler Operation and Component Diagnostics

WILO Pump Operational LED Indicators

Explains the meaning of different LED states on WILO pumps for normal and fault conditions.

Expansion Vessel Servicing Procedure

Step-by-step guide to correctly service the ATAG expansion vessel and remove condensation.

Zone Manager and Light LED Signals

Details the LED signals for Zone Managers, indicating power, communication, and operation errors.

Related product manuals