Page GB-20
Default-Time
Push for approx. 3 seconds
Reloading of standard program - deleting of individual timeprogram
6622..55
1155::3300
WWEE.. 2255 .. JJUUNN..;;0033
°C
TTIIMMEEPPRROOGGRRAAMMSS
HHCC
TTIIMMEEPPRROOGGRRAAMMSS
SSTTAANNDD.. PPRROOGGRR..
Enter timeprogram level
Standard display
select
accept
Example: Unmixed circ.
accept
Change - Exit :
Each flashing adjustment value can be corrected by means of the
rotary pushbutton and accepted by pressing the button again.
Return to the previous step by means of button
¤¤
,
return to stan-
dard display by means of button
¢¢
or automatically after approx.
60 seconds.
select
Heatingcircuit
3sec.
DDEEFFAAUULLTT--TTIIMMEE
HHCC
DDEEFFAAUULLTT--TTIIMMEE
MMCC--11
DDEEFFAAUULLTT--TTIIMMEE
MMCC--22
DDEEFFAAUULLTT--TTIIMMEE
DDHHWW
DDEEFFAAUULLTT--TTIIMMEE
AALLLL
j
An individually generated timeprogram can be replaced by its stan-
dard program as shown in the opposite programming schematic.
However, in such cases the individually generated timeprogram will
be irrevocably deleted. For this purpose individual switch-on and
switch-off times as well as specified temperatures should always be
recorded in writing (see page 22-23).
1) 1)
GB
8A521100_GB.qxd 10.11.2004 12:05 Seite 20
To Next Page
Loading...