Operating Instructions ATAG QR-Series
4
1 Introduction
These operating instructions describe the functioning and the operating of the ATAG Q
boilers.This manual is for the end user. For installation and servicing there is an instal-
lation & servicing instructions manual for the installer. (pag. 16).
Read this manual fully before operating the boiler. In case of doubt or errors contact
your installer.
ATAG Commercial reserves the right to change the specications and dimensions without
prior notice.
Work on the boiler must be carried out by a competent person, (Ref: Gas Safe Register)
using correctly calibrated instruments with current test certication.
When replacing parts use only ATAG Service parts.
Contact details for ATAG Heating UK Ltd can be
found on the back page of this manual.
The Benchmark Scheme
ATAG Heating UK Ltd is a licensed member of the Benchmark Scheme which aims to
improve the standards of installation and commissioning of domestic heating and hot
water systems in the UK and to encourage regular servicing to optimise safety, eciency
and performance.
Benchmark is managed and promoted by the Heating and Hotwater Industry Council.
For more information visit www.centralheating.co.uk
Please ensure that the installer has fully completed the Benchmark Checklist on the
inside back pages of the installation instructions supplied with the product and that you
have signed it to say that you have received a full and clear explanation of its operation.
The installer is legally required to complete a commissioning checklist as a means of
complying with the appropriate Building Regulations (England and Wales).
All installations must be notied to Local Area Building Control either directly or through
a Competent Persons Scheme. A Building Regulations Compliance Certicate will then
be issued to the customer who should, on receipt, write the Notication Number on the
Benchmark Checklist.
This product should be serviced regularly to optimise its safety, eciency and perfor-
mance. The service engineer should complete the relevant Service Record on the Ben-
chmark Checklist after each service.
The Benchmark Checklist may be required in the event of any warranty work and as
supporting documentation relating to home improvements in the optional documents
section of the Home Information Pack.
To Next Page
Loading...
Need help?
General
