7
Mount the freezer and refrigerator
compartment doors
Feed water pipe Installation
Pass the refrigerator laterally through the access
door as shown in the right figure.
$
Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm
2
) (That is, an instant paper cup (180cc) will be fully filled within 3 sec.).
$
If water pressure does not reach the rating 147kPa (1.5kgf/cm
2
) or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
$
Keep the total length of the feed water pipe tube within 12m and be careful for the
tube not be bent straightly. If the tube is 12m or longer it may cause trouble in
water feed owing to the drain water pressure.
$
Install the feed water pipe tube at a place free from heat.
$
Connect to potable water supply only.
Mount them in the reverse sequence of removal after they pass through the access
door.
Pass the
refrigerator
Before
installation
Warning
Installation
To Next Page
Loading...
