You can vary the temperature as shown below:
60 °C / 70 °CHeavy wash:
60 °C / 65 °CNormal wash:
60 °C / 65 °CDaily wash:
30 °C / 60 °CQuick wash:
40 °C / 50 °CDelicate wash:
50 °C / 55 °CEco wash:
55 °C / 65 °CUpper half:
55 °C / 65 °CLower half:
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option.
This causes a slight increase in energy consumption. This option
can be used with all programmes except Time program, Hygiene
wash and Rinse & Hold. This option cannot be activated if the
Time saver option is selected.
If you want a programme with Short dry, press again so that the
field under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start 1-24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at
a time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the
programme.
Set time
Press the option button several times – or hold it in – to set the
desired programme time for Time program. You can choose a
programme time between 30 minutes and 3 hours.
Time saver
This option shortens the programme time, but uses more energy
and water. This option can be selected with the programmes
Heavy wash, Normal wash, Daily wash, Upper half and Lower
half.
Start the dishwasher
Press and hold Start/Stop until the display shows (the door
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last programme run.
Time remaining
Once you have selected a programme and options, the display
indicates how long the programme took the last time it was used.
The remaining time is updated after the water for the final rinse
has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature and other factors.
NOTE!
During the first run of each programme, the remaining time
displayed can be slightly misleading, as the dishwasher is
estimating the time. When you run the programme a second
time, the dishwasher will calculate the remaining time based
on the previous duration of the programme.
Status light
The status light at the bottom on the dishwasher provides
information by means of 3 different colours. Adjust the status light
so that it is seen clearly by pulling out or pushing in the
transparent plastic strip.
Blue
Load more. The programme has started, but you can still load
more dishes.
Red
Do not load. You should not load more dishes (risk of poorer
dishwashing result).
Flashing red
This indicates a fault. See further in the section Troubleshooting.
Green
Unload. The dishwashing programme is finished. Standby light
for two hours.
Stopping or changing a programme
If you want to change programme after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new programme, press Start/Stop and
close the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the
programme.
10
To Next Page
Loading...
