Atag WIZE User Manual

31
1.Outsidetemperature.If_
__°Cappearsonthescreen,
then there is no outside sensor
connected or it is not working.
2. Pressure of central heating
installation.
The correct pressure has to be
between 1.4 and 1.7 bar. Also
have a look at the boiler to read
the water pressure allowing you
a proper check and top up if
required.Youmayalsoreferto
the boiler’s manual.
3. Central heating’s input tem-
perature inside the boiler
4. Burner capacity
0%=offorlowsetting
100%=fullload
The
symbol on the standard
screen tells you whether the
burner is on.
5.Hotwatertemperature(Not
every boiler type displays this
temperature)
6. Hot water quantity (in litre/
min (±10%) for a combination
boiler)
7.1:Boileroperationalfor
hot water (or the waiting time
afterwards)
0:boilernotoperationalforhot
water
8. Central heating’s return tem-
perature inside the boiler
9. Current room temperature
(as measured by the clock ther-
mostat). This value is accurately
displayed per 0.1°C.
previous next
previous back to start

Atag WIZE Specifications

General

Brand	Atag
Model	WIZE
Category	Thermostat
Language	English