AT&T 922 User Manual

I N S TA L L AT I O N
NOTE: This telephone requires a
2-line modular jack or two separate
one-line modular jacks to use this
unit as a two-line phone.
NOTE: To use both lines of a two-
line telephone, your local telephone
company must provide two telephone
numbers.
Batteries
NOTE: The base must be removed to
install batteries.
Before using the telephone, you
should install AA batteries (not
included). If you are connecting only
Line 1 or only Line 2, use two
batteries, as indicated on the bottom
of the phone. If you are connecting
both lines, use four batteries.
You can use the phone without
batteries to make and receive calls,
but it requires batteries to power the
Line Status lights.
If you have wall-mounted the
telephone, follow these directions:
1 Remove the telephone from
the wall.
2 Turn the telephone upside down.
3 Remove the base by pressing the
tabs located on the top of the base.
4 Press down on tab on battery
door located between arrows on
battery door (Figure 2A). Swing
door open and insert new batteries
(Figure 2B).
5 Close the battery door.
C AU T I O N : A lways unplug the line
c o rd befo re installing new AA bat t e ri e s .
Conferences
both lines
Directory Card/Cover
Line 2 Ringer Volume
Accesses memory
dialing numbers
Redials last call made, or starts Auto Redial
Mutes a call
Access Call Waiting
or other services
Temporary
Tone
Line 1 Ringer Volume
Handset
Line selection
Line Status
Lights
Programs a number
in memory
Programs a pause
in memory
One-Touch
Memory Locations
Two Touch
Memory Locations
Puts a call on hold
Turn speaker on or off
Speaker/Handset Volume
Accesses two-touch
memory dialing numbers
Figure 1
Press down on tab to
open battery door
Insert two
AA batteries for Line 2
Insert two AA batteries for Line 1
BATTERY DOOR CLOSED,
BASE OFF
BATTERY DOOR OPEN,
BASE OFF
Figure 2BFigure 2A
1

AT&T 922 Specifications

General

Brand	AT&T
Model	922
Category	Telephone
Language	English