9
INSTALLATION
2 Install one 9V battery.
• Press in on the tabs and remove the telephone base.
• Use a small Phillips head screwdriver to remove the screw
and open the battery door.
• Insert the 9V battery (included), and replace the screw to
close the battery door.
• Replace the telephone base.
NOTE: The battery retains telephone memory in the event of a power
failure. If power fails and a working battery is installed, all four lines
of this phone will work only to answer calls with the handset or headset,
and dial calls using the keypad and the Speed Dial or Redial features.
No other features will work until power is restored.
3 Connect the telephone line cords to the telephone.
Please refer to line cord connection instructions in Step 2 of
“Table/Desk Installation’ on page 7.
4 Turn the base, as shown, and attach it to the bottom of
the phone.
To Next Page
Loading...
