86
Adding and registering handsets/headsets
Your telephone can support up to ve DECT 6.0 cordless handsets (AT&T
model B102-0, sold separately) or up to three cordless handsets and 2
cordless headsets (sold separately). Visit
https://telephones.att.com/headsets for a list of compatible DECT
6.0 cordless headsets. Each new handset or headset must be registered to
the telephone base before use. You must register each handset or headset
separately.
To register a cordless headset to this telephone system, please refer to the
user’s manual of the cordless headset for more details. To register a cordless
handset, see below.
The handsets provided within your product box are already registered as
HANDSET 1, and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 5).
Register a handset to your telephone base
1. Before you begin registration, make sure the handset
is out of the telephone base or charger and shows To
register HS... and ... see manual.
2. Put the handset you wish to register on the telephone
base cradle.
3. The handset shows Registering... and the IN USE light
on the telephone base turns on. If the registration is
successful, the handset screen displays Registered and
beeps. The handset is now registered with the telephone
base.
If registration fails, the screen shows To register HS... and ... see manual.
Please start again from Step 1.
Appendix
For registration, put the handset on the telephone
base, not the handset charger.
... see manual
ECO
To register HS...
ECO
Registering...
ECO
Registered
ECO
To Next Page
Loading...
Need help?
General
