AT&T CL4940 Manual

37
Answering system
Answering system settings
Message alert
If the message alert is set to On, you can hear the telephone beeps every 15
seconds when there are new messages.
To change the setting:
When the telephone is in idle mode, press
MENU/SELECT to enter the main menu.
Press MENU/SELECT again to select Answering sys.
Press CALL LOGq or DIRECTORYp to scroll to Message
alert, then press MENU/SELECT.
Press CALL LOGq or DIRECTORYp to choose On
or O.
Press MENU/SELECT to save the setting. There is
a conrmation tone and the screen returns to the
previous menu.
Remote code
To access your answering system remotely from any touch-tone phone, you
need to enter a three-digit number. The default remote access code is 500.
To change the remote code:
When the telephone base is in idle mode, press
MENU/SELECT to enter the main menu.
Press MENU/SELECT again to select Answering sys.
Press CALL LOGq or DIRECTORYp to scroll to Remote
code, then press MENU/SELECT.
Use the dialing keys to enter a three-digit number.
Press MENU/SELECT to save the setting. You hear
a conrmation tone and the screen returns to the
previous menu.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
Remote code
500
Call screening
>Message alert
p
q
On
>Off
p
Message alert
>Remote code
p
q

AT&T CL4940 Specifications

General

Type	Analog telephone
Answering machine	Yes
Mounting type	Wall
Product color	White
Languages support	ENG, ESP
Dialer location	Base
Phonebook capacity	25 entries
Call log entries	50
Wireless connection	No