55
Appendix
Part 15 of FCC rules
Some telephone equipment generates, uses, and can radiate radio-frequency energy and, if not
installed and used properly, may cause interference to radio and television reception. This product
has been tested and found to meet the standards for a class B digital device, as specied in Part
15 of the FCC rules.
These specications are designed to provide reasonable protection against such interference
in a residential installation. However, there is no guarantee that interference will not occur in a
particular installation.
If this product causes interference to radio, VCR or television reception when it is in use, you might
correct the interference with any one or all of these measures:
Where it can be done safely, reorient the receiving radio, VCR or television antenna.
To the extent possible, relocate the radio, VCR, television or other receiver with respect to the
telephone equipment.
If this telephone product runs on AC power, plug your product into an AC outlet that’s not on
the same circuit as one used by your radio, VCR or television.
Consult a dealer or an experienced radio/TV technician for help.
Modications to this product, not expressly approved by the manufacturer, could void the
user’s authority to operate the equipment.
This Class B digital apparatus complies with Canadian requirement:
CAN ICES-3 (B)/NMB-3(B)
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Privacy of communications may not be ensured when using this telephone.
The term ‘’IC: ‘’ before the certication/registration number only signies that the Industry
Canada technical specications were met.
The Ringer Equivalence Number (REN) for this terminal equipment is 0.7. The REN is an indication
of the maximum number of devices allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of devices subject only to the
requirement that the sum of the RENs of all the devices does not exceed ve.
This product meets the applicable Industry Canada technical specications.
To Next Page
Loading...
Need help?
General
