Multiple handset use
30
Push-to-talk (PTT)
Answer an incoming call during PTT
When you receive an incoming outside call during PTT, there is an alert tone.
During a one-to-one PTT, press PHONE/FLASH on the initiating or
destination handset. The PTT call ends automatically and the outside call
is answered.
During a one-to-group PTT, press PHONE/FLASH on the initiating handset.
The PTT call ends automatically and the outside call is answered.
During a one-to-group PTT, press PHONE/FLASH on any one of the
destination handsets and that handset answers the outside call. The PTT call
continues for the rest of the PTT participants.
To leave the PTT call without answering the incoming call, press
OFF/CANCEL. The telephone continues to ring.
Make an outgoing call during PTT
During a one-to-one PTT, press PHONE/FLASH to get a dial tone. The PTT
call ends automatically.
During a one-to-group PTT, press PHONE/FLASH on the initiating handset.
The PTT call ends automatically and you get a dial tone.
During a one-to-group PTT, press PHONE/FLASH on any one of the
destination handsets and that handset gets a dial tone. The PTT call
continues for the rest of the PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination handsets can end PTT.
For PTT calls to a group of handsets, the initiating handset can end the PTT
call for the group of handsets on the PTT call. If any one of the destination
handsets leaves the PTT call, the call continues until all participants or the
initiator hangs up.
Press OFF/CANCEL or place the handset in the telephone base or charger.
The handset screen shows Push to talk Ended.
NOTE: After PUSH TO TAL� is released, the PTT call remains open for a short time. If no one
presses PUSH TO TAL� within 10 seconds, the PTT call ends automatically.
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
